ENCLOSURE FOR MICROCHIP MPLAB SNAP DEBUG BOARD PG164100 PROTECTIVE BOX

3D PRINTED ENCLOSURE FOR THE PG164100 
MICROCHIP MPLAB SNAP IN-CIRCUIT DEBUGGER

Printed in PTG for high durability 
as well as moisture and chemical resistance.
Provides access to the PIC/AVR mode jumper, 
and resin window for the activity and status leds

The provided pin extender will be very usefull especially on
crowded boards where the MPLAB Snap would have trouble to connect

This easy to assemble enclosure will protect Your hard to get programmer / debugger
from the most common mechanical fault - the micro USB connector breaking off. It also
provides a good level of moisture and dust protection, and will keep Your Snap safe in Your workshop.

Set includes: enclosure front and back, mounting screws, pin extender.
The MPLAB Snap board is NOT INCLUDED.